Using the method of joints, determine the force in each member of the truss shown. State whether each member is in tension or compression.
Home/Mechanical Engineering
Mazurek Gravity Latest Questions
A differential band brake is shown in Figure. The diameter of the drum is 800 mm. The coefficient of friction between the band and the drum is 0.3 and the angle of embrace is 240°. When a force ...Read more
Anonymous
Asked: 2 months agoIn: Mechanical Engineering
A block weighing 500 N just starts moving down a rough inclined plane when it is subjected to 200 N force acting up the inclined plane and it is at the point of moving up the plane when ...Read more
0.3 Kg of Nitrogen gas at 100 kPa and 40°C is contained in a cylinder. The piston is moved compressing nitrogen until the pressure becomes 1 MPa and temperature becomes 160°C. The work done during the process is ...Read more
What is the value of P in the system shown in Fig. below to cause the motion to impend? Assume the pulley is smooth and coefficient of friction between the other contact surfaces is 0.2.
If angle of BC with horizontal is 20° then find out tension in AC and BC.
A ball of weight Q=12lb rests in a right angles trough, as shown in figure B.Determine the forces exerted on the sides of the trough at D and E if all surfaces are perfectly smooth.
A bar of length 1000 mm and diameter 30 mm is centrally bored for 400 mm, the bore diameter being 10 mm as shown below. Under a load of 30 kN, if the extension of the bar is ...Read more
Using the method of joints, determine the force in each member of the truss shown. State whether each member is in tension or compression.
A screw jack raises a load of 40 KN. The screw is square threaded having three threads per 20 mm length and 40 mm in diameter. Calculate the force required at the end of a lever 400 mm ...Read more